BetterPhoto Q&A
Category: Problems with Photo Equipment - Tips & Tricks

Photography Question 

Tom Sacchet
 

Image Quality with Canon 20d


Hi...I purchased the Canon 20d and absolutly love the quality, sharpness, and clarity I get with photos taken 3 feet or less.

My photos taken with the subject more than 3 feet away seem to be not sharp or clear.

I use a canon 50mm f/1.8 lens and the close up photos are outstanding.

Can someone tell me what is wrong with the photos where the subject is more than 3 feet away.

Thanks
Sacchet


To love this question, log in above
May 14, 2005

 

Jon Close
  Can you post an example?


To love this comment, log in above
May 15, 2005

 

Karthik M. Siddhun
  Hi Tom,
It would be great you post the pics which are sharp (close up) as well as pics which are 3 feet away. We can able to guide you.

With regards,
Siddhun.M.Karthik


To love this comment, log in above
May 16, 2005

 

KIM SCHULTZ
  You've had the camera a while, so you have probably checked this, but the camera's standard setting (preferences) for sharpness is not at it's highest setting. I found that I liked the crisp image better and have reset mine to the highest level. The standard setting gave my photos a "soft" look, especially with subjects farther away.


To love this comment, log in above
May 17, 2005

 

Nick Milton
  just a thought but try using only the centre focus and one shot mode,and check the dof?are you shooting distance wide open on f1.8???

nick.


To love this comment, log in above
May 24, 2005

 

Arthur Y. Sprague
  Dumb question.
Is it perhaps set on Manual Focus?
Or is Autofocus non-functional?

Arthur


To love this comment, log in above
June 16, 2005

 

Joe Jarosz
  Without seeing an example picture its hard to say, but what has already been mentioned are all good things to check. Most of the time I have seen problems are when the wrong autofocus point is selected. The 20D has 9 focus points, so if you are focusing on a scene, and it picks up a focus point to the left right or lower than what you are shooting, it may come out out of focus. Try what Nick mentions, select a single focus point on what you want to shoot. As for the in camera sharpening, I'd recommend leaving that set low in the camera and adjust in photoshop. Its easier to increase in photoshop than decrease a picture thats already to sharp coming out of the camera. More control that way.


To love this comment, log in above
June 16, 2005

 
This old forum is now archived. Use improved Forum here

Report this Thread